12
®
Link in
The link from the transmitter to each receiver module is made using a twisted
pair cable, specified to Category 5 or higher.
When a single receiver is attached to a link cable, the maximum length of that
link cable is 300 metres (1000 feet).
However, if further receivers are connected in cascade to the initial receiver
(using the
LINK OUT
port – Wizard AVU5111A modules only), then the overall
length of the link cables used must be reduced. For further information, please
refer to the section
.
NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside
power cables.
1 Attach the connector of the link cable to the socket labelled
LINK IN
on the Wizard receiver. There should be a click
when the cable is fully inserted and locked in
place.
Connections at the receiver
To connect displays and speakers
Dual video and audio outputs are provided on the Wizard receiver. Both sets of
ports provide identical signals and their connection procedures are the same:
1 Attach the video cable from the display module to the socket
labelled
OUT
on the Wizard receiver.
2 Attach the stereo audio cable from the speakers
(or amplifier) to the socket labelled
OUT
on the
Wizard receiver.
