10
®
To connect the link cable(s)
The links between the transmitter and receiver modules are made using between
one and four twisted pair cables, specified to Category 5 or higher. Each cable
carries video and audio signals to each receiver module.
When a single receiver is attached to a link cable, the maximum length of that
link cable is 300m (1000 feet).
Wizard AVU5004A models
1 Attach the connector of the first link cable to the socket
labelled
LINK1
on the Wizard AVU5004A transmitter.
There should be a click when the cable is fully
inserted and locked in place.
2 Attach the connectors of the remaining
link cables to the sockets labelled
LINK2
to
LINK4
, as required.
In all cases, there should be
a click when the cable is fully
inserted and locked in place.
However, if further receivers are connected in cascade to the initial receiver using
its
LINK OUT
port (Wizard AVU5111A models only), then the overall length of the
link cables used must be reduced. For further information, please refer to the
section
.
NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside
power cables.
Wizard AVU5001A models
1 Attach the connector of the link cable to the socket labelled
LINK
on the Wizard AVU5001A transmitter. There should
be a click when the cable is fully inserted and
locked in place.
