15 of 24
GET RACK N
This command is not supported in the 2U Auto Bypass Switch. If this command is issued to the 2U Auto Bypass
Switch it will respond with the following:
Rack Status: XXXXXXXXXXXXXXXX
GET PORT N
Displays the status of A/B switching element N (1-2). The response will be “A” or “B”.
Port Status: B
SET PORT N A[B]
Sets the addressed A/B switching element N (1-2) to position A or B. Note that the 2U Auto Bypass Switch only
uses the first two A/B switching elements. Setting the switch state of any of the other 14 positions is not meaningful.
GET POWER N
This command is not supported in the 2U Auto Bypass Switch. If this command is issued to the 2U Auto Bypass
Switch it will respond with the following:
Power Status: External Supply
SET IPADDRESS X.X.X.X
GET IPADDRESS
Set or display the current IP address of the network module. Any change will not become permanent until a SAVE
operation is performed.
SET SUBNETMASK X.X.X.X
GET SUBNETMASK
Set or display the current subnet mask of the network module. Any change will not become permanent until a
SAVE operation is performed.
SET GATEWAY X.X.X.X
GET GATEWAY
Set or display the current gateway IP address of the network module. Any change will not become permanent until
a SAVE operation is performed.
SET READCOMMUNITYNAME string
GET READCOMMUNITYNAME
SET WRITECOMMUNITYNAME string
GET WRITECOMMUNITYNAME
Set or display the current read or write community name as specified. Note that these are case sensitive fields. Any
change will not become permanent until a SAVE operation is performed.
SET WEBENABLE ON[OFF]
GET WEBENABLE
Set or display the current state of web based access. The network module will not accept any HTTP requests when
web enable is off. Any change will not become permanent until a SAVE operation is performed.
