106
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
VALUE
DESCRIPTION
0
Restores the factory setup
1
Prints out the active setup selections
2
Restores the setup selections stored in the permanent memory to
active status
NOTES
If a document is printed using temporary host-download commands
(commands not stored using the Z99,0 command), value 2 will restore
the permanent memory selections.
Put a &%Z98,2 at the end of the document to restore the standard setup
parameters for the next user of the printer.
The active setup and permanent memory setup selections are the same
after a Command Z99,0 or a Command Z98,2 is sent to the printer.
Example: &%Z98,1 prints out the active setup selections for review.
COMMAND 99: STORE CONFIGURATION IN PERMANENT MEMORY
Send this command after all desired host-download configuration commands have
been sent to the interface. It stores the active setup in the permanent memory of
the interface so it will be in effect whenever the printer is powered on. Otherwise,
active configuration commands are lost when the printer is turned off.
VALUE
DESCRIPTION
0
To complete the command, the value 0 must be used
NOTE
Host-download selections followed by a Command Z99,0 will be stored
in permanent memory and active when the printer is turned on. Only
use Command Z99,0 when the host-download selection needs to be
permanently stored in the memory of the interface.
Example: &%Z99,0 stores the currently active setup selections in the permanent
memory of the interface.
