The bottom of the configuration screen displays status messages as appropriate. When the
CONFIGURE
line is set to
ACCEPT
the following line will normally appear:
Use cursor keys to select parameter, SPACE/- to toggle
Two additional lines appear when the CONFIGURE line is set to ENTER, as follows:
Type <CTRL>&A to enable access to link parameters
Use cursor keys to select parameter, SPACE/- to toggle
Select ACCEPT to apply changes, type <CTRL>&C to abort
If <CTRL> and A are keyed simultaneously then the top line changes to:
Type <CTRL>&A to enable access to link parameters
If the remote unit is put into a composite loopback mode the local unit can not be configured
and the following message is displayed:
Looping data back to remote - Keyboard Disabled
Error Messages
Error messages take precedence over any existing message and always appear on the top of
the three previously described lines. The possible error conditions are as follows:
WARNING - MAXIMUM AGGREGATE SPEED EXCEEDED
WARNING - LOCAL AND REMOTE SET-UPS DO NOT MATCH
Data Channel Configuration
The display shows parameters for eight data channels CH1 to CH8. Each data channel has
parameters selectable as shown in the following table.
