User Manual
5.4.4 ALARM command
The ALARM command informs the user about urgent and non-urgent alarms. Upon entering the
<C> parameter, the updating of the information on the screen will occur automatically with the
interval of 5…20 seconds according to the parameter set by the TRACETIME command:
Alarm Status
Urgent:
LossSync – ON
HiEPR - OFF
Not-urgent:
Link – OFF
LoEPR - OFF
SQ - OFF
NTU_FMM>
5.5 Configuration management submenu
Upon activation of the configuration management submenu the following message will be displayed.
01:47:50
Configuration management activated
Enter <M> to return to MAIN, or <H> for HELP information
NTU_CM>
Press <H> to see all available commands with their brief description.
01:47:50
Configuration management activated
Enter <M> to return to MAIN, or <H> for HELP information
NTU_CM>H
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
CONFIG
Display local configuration
RESET System
Reset
MASTER ON|OFF
Set xDSL master/slave mode (similar to CO/RT)
LINERATE [1..8]
Select line rate
ADAPTIVE ON|OFF
Set adaptive mode to ON/OFF ( only for slave mode)
DEFAULT [0..1]
Set default configuration
ESPEED [AUTO|10|100]
Set speed of Ethernet port
EMODE [AUTO|HALF|FULL]
Set Duplex mode of Ethernet port
TRACETIME [5..20]
Change trace time (5..20 seconds)
M(AIN)
Return to main menu
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NTU_CM>
5.5.1 TRACETIME command
The TRACETIME command allows the user to change the time interval of updating the information
on the screen (5…20 seconds):
NTU_CM>TRACETIME 10
NTU_CM>
Page 19 of 30
