User Manual
5.3.2 LINE command
The LINE command informs the user about the status of the connection over the physical line. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically
with the interval of 5…20 seconds according to the parameter set by the TRACETIME command:
Line Port Statistics
LOCAL REMOTE
-------------------------------------------------------------------------
5 sec Total 5 sec Total
Transmit Packets 10 15 9 27
Receive Packets 12 25 5 15
Receive Error Packets 0 0 0 0
Error Packet Rate, % 0.00 0.00 0.00 0.00
Receive Bytes 449 3418 1272 1992
Transmit Bytes 1 1993 1536 3101
Average Speed, kBps 0 0 1 0
-------------------------------------------------------------------------
Software Version 1.41 1.4
Link Up
Line Speed, kBps 656
Signal Level, dBm 16.0 16.0
Far-End Level, dBm 0.0 0.0
Noise Level, dBm 15.5 15.5
NTU_PM>
5.3.3 ETH command
The ETH command informs the user about the status of the connection over the Ethernet port. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically
with the interval of 5…20 seconds according to the parameter set by the TRACETIME command:
Ethernet Port Statistics
Speed 100M Duplex Mode Full
Link State Link Up
Input Output
5 sec Total 5 sec Total
Octets 64 9775 1110 19746
Ucast Packets 0 0 0 10
NUcast Packets 0 20 14 224
Discards Pckts 1 74 0 0
Errors 0 0 0 0
NTU_PM>
Page 15 of 30
