Black Box MD3310-R2, User Manual

Page: 20 / 50

17
CHAPTER 5: Operation Mode Selections
Table 5-1. Mode 6 Hardware Settings
Modem Direct Connect
Data Rate Matches baud rate on the modem
Flow Control RTS/CTS
Parity None
Advanced Hardware Settings:
Connection started by (calling PC) Always connected
Connection ended by (calling PC) Always connected
Connection started by (host PC) Carrier Detect
Connection ended by (host PC) Carrier Detect
DTR signal state Always on
RTS signal state Always on
Instruct pcANYWHERE to run a script file after connection (under advanced host
PC settings). This script file will allow any of the parameters shown in Table 5-2 to
be changed and will program the modem to call the appropriate entry in its Call
Book.
Figure 5-1 provides an example of how the commands in the script file should be
written. This script file does the following:
• Sets the Minimum Packet Size to position 2
• Sets the Transmit Rate to 1
• Sets the Maximum Packet Size to position 9
• Sets the Frequency Key to 9
• Sets the RF Data Rate to 2
• Sets the Transmit Power to 9 (full power)
• Programs the modem to call position 2 in its Call Book. This entry corresponds
with the pcANYWHERE entry with which we are trying to establish a
connection.