31
CHAPTER 8: Call Book Selections
Figure 8-1. The Modem Call Book Menu.
8.1 Entering or Modifying Numbers in the Call Book
Entering or modifying serial numbers in the Call Book is a straightforward process.
When in the Call Book menu, enter the position number (0 to 9) you wish to edit.
You will be prompted for the new number (formatting is automatic; you do not
need to enter the dash). Once the number is entered (unless it is 000 to 0000), you
will be asked for the number for the repeaters to be used. If no repeaters are to be
used, press the escape key; your entry will be complete and you will be back in the
Call Book menu screen. If you enter a repeater number, you will then be promp-
ted for the number of the second repeater to use. If a second repeater is being
used, press the number at this time; if not, press the escape key. Once again the
modem will retain your entries, as shown in the updated Call Book menu screen.
NOTE
Fill the Call Book slots (0 - 9) sequentially beginning with 0 (the first slot
in the book). Serial numbers do not need to be entered in numerical
order; however, there must not be any 000-0000 numbers in the middle
of the list of good serial numbers. The reason for this is that when a
master is instructed to Call All available slaves, it will call all slaves
listed until it reaches the first phone number of 000-0000. If a valid serial
number is entered after the all zero number, it will not be recognized as
a valid number to call by the master.
Terminal-TERMINAL.TRM
File Edit Settings Phone Transfers Help
DGR 900S MAIN MENU
Modem Serial Number 554-0024
(0)
Set Operation Mode
(1)
Set Baud Rate
(2)
Edit Call Book
(3)
Edit Radio Transmission Characteristics
(4)
Show Radio Statistics
(Esc) Exit Setup
Enter Choice 2
MODEM CALL BOOK
Entry to Call is 04
Entry Number
Repeater 1
Repeater 2
(0)
555-0025
(1)
555-0017
555-0011
(2)
555-0013
(3)
555-0025
555-0018
(4)
555-0001
555-0011
(5)
000-0000
(6)
000-0000
(7)
000-0000
(8)
000-0000
(9)
000-0000
(C)
Change Entry to Use (0-9) or A(ALL)
(Esc) Exit to Main Menu
Enter all zeros (000-0000) as your last number in list
Summary of Contents for MD3310-R2
Page 3: ......
