EN
G
LI
SH
ENGLISH
24
26
25
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage.
Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
24 CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet
(see
step 2
). Remove Handle (
See step 23
). Remove the Dome Cap (
24A
) by unscrewing
it in a counterclockwise direction. Using an adjustable wrench, unscrew the Retainer
Ring (
24B
). Carefully remove the Cartridge (
24C
) by pulling it straight up and out.
Inspect Cartridge (
24C
) for debris or damage. Clean or replace the Cartridge (
24C
).
Reassemble faucet by reversing steps.
25 DIVERTER REPLACEMENT
(
For products with side spray
). If the side spray fails to work properly the diverter
mechanism may be clogged with debris or may need replacing. To check and/or replace
Diverter (
25A
),
shut off water supply and relieve pressure before working on your
faucet
(
see step 2
). Remove handle (
see step 23
) and Dome Cap (
25B
) and carefully
lift up the Spout Assembly (
25C
). The Diverter Mechanism (
25A
) is located on the
backside of Inner Faucet Body (
25D
). Carefully remove the Diverter Mechanism (
25A
)
and check for debris. Clean or replace the Diverter Mechanism (
25A
). Reassemble
faucet by reversing steps.
26 SIDE SPRAY HOSE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet.
To remove the quick connect attachment, push up on the Quick Connect Housing (
26A
).
Holding grey Plastic Colette (
26B
) in place, pull downward on Quick Connect Housing
(
26A
) until Tube (
26C
) is free.
7
26A
26A
26B
26C
24A
25B
25C
25D
24B
24C
25A