EN
G
LI
SH
ENGLISH
14
16
15
17
14 FAUCET PREPARATION
From underneath faucet, remove Nut (
14A
) from Mounting Post (
14B
). Remove Putty
Plate (
14C
) and Deck Plate (
14D
) from Faucet Body (
14F
). Assemble Mounting Ring
(
14E
) and Putty Ring (
14G
) to Faucet Body (
14F
). Secure by placing and threading Nut
(
14A
) onto Mounting Post (
14B
).
15 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in Putty Ring (
15A
). Insert the faucet Supply Tubes (
15B
) through the center
hole of the sink.
16 SECURING FAUCET TO DECK
Remove any excess putty from around the outside edge of Mounting Ring (
16A
). From
underneath sink, secure the faucet by placing the Metal Washer (
16B
) and the Long
Nut (
7
/
16
Hex.) (
16C
) onto the Mounting Post (
16D
). Make sure that the bumps on the
Metal Washer (
16B
) are facing up. Tighten until the faucet is firmly connected to the
sink.
Do not over tighten!
17 WATER SUPPLY CONNECTIONS
A.
Thread Inlet Connectors (
17A
) into Water Supply Lines (
17B
).
B.
Remove Protective Cap (
17F
). Gently separate hot and cold Faucet Inlets (
17C
),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (
17B
) onto Faucet Inlets
(
10C
). Hot water supply line goes to hot inlet fitting indicated by red tag.
C.
Insert Clip (
17D
) into Inlet Connector Holes (
17E
) to secure water supply lines, as
shown.
Water Supply Lines are not included. Please consult
manufacturer and/or its instructions for the correct
method of installation of supply lines and fittings.
CAUTION:
Incorrect application of supply lines and fittings may
result in the failure or leak of the supply lines and fittings.
5
16A
16D
16B
16C
14A
14B
14C
14D
14F
14F
14A
14B
14E
14G
15A
15B
1" Max.
(26 mm)
A
B
C
17A
17B
17C
17C
17C
17C
17A
17F
17B
HOT
COLD
17D
17E
17B
17D
17B
17A