10
4. When the desired pressure is reached, the compressor will
automatically stop. Press the Compressor Power Button again to turn
off the unit.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the nozzle adapter from the Sure Fit
®
nozzle.
7. Allow the unit to cool, then recharge before storing away.
8. Store the compressor hose, Sure Fit
®
nozzle and nozzle adapter in the
storage compartment.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at
higher temperatures. When the unit is not in use, we recommend that the
battery is charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the
outer surfaces of the unit with a soft cloth.
There are no user-replaceable parts. Periodically inspect the condition
of adapters, connectors and wires. Contact manufacturer to replace any
components that have become worn or broken.
Battery
Please be advised that the battery is designed to last the service life
of the unit and is not replaceable, removable or serviceable.
Service life
is dependent on a number of factors including but not limited to the number
of recharge cycles, and proper care and maintenance of the battery by the
end user. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid
battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result in
injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Unit will not charge
• Make sure the AC/USB power button has
been pressed to turn the inverter off.
• Make sure a suitable gauge extension
cord is properly connected to both the unit
and a functioning AC outlet.
Unit fails to jump-start
• Make sure the unit is not being operated
in the Compressor mode.
• Make sure unit’s Jump Starter Power
Switch is in the on position.
• Make sure a proper polarity cable
connection has been established.
• Check that unit has a full charge.
Recharge unit if necessary.
120 volt AC outlet will not
power appliance
• Make sure the AC/USB power button has
been pressed to turn the inverter on.
• Make sure you have followed all the steps
in the 120 AC portable power supply
instructions carefully.
• Make sure the appliance being powered
does not draw more than 500 watts
• Refer to the important notes included
in that section that explain common
problems and solutions.
• Check that unit has a full charge.
Recharge unit if necessary.
12 volt DC accessory
outlet will not power
appliance
• Make sure the the appliance does not
draw more than 5 amps.
• Check that unit has a full charge.
Recharge unit if necessary.
USB power port will not
power appliance
• Make sure that the total draw of the USB
device plugged into the USB port does not
exceed 2A.
• Make sure the AC/USB power button has
been pressed to turn the USB ports on.
• Some USB-powered household electronics
will not operate with this USB charging/
power port. Check the manual of the
corresponding electronic device to confirm
that it can be used with this type of USB
charging/power port.
• Check that unit has a full charge.
Recharge unit if necessary.
LED area light does not
come on
• Make sure the area light power button has
been pressed to turn the area light on.
• Check that unit has a full charge.
Recharge unit if necessary.
Portable compressor will
not inflate
• Make sure the unit is not being operated
in Jump Starter mode.
• Make sure the compressor power button
has been pressed to turn the compressor
on.
• Make sure the Sure Fit
®
nozzle connector
is securely screwed on to the valve stem
when attempting to inflate tires; or that
the nozzle adapter is securely screwed
into the Sure Fit
®
nozzle connector and
is inserted properly into the item to be
inflated on all other inflatables.
• The compressor may be overheated. Press
the compressor power button to turn the
compressor off. Restart after a cooling
down period of approximately 30 minutes.
• Check that unit has a full charge.
Recharge unit if necessary.
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact
the manufacturer at 1-877-571-2391.
WARNING:
The use of any accessory not recommended for use with
this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement
parts, contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR HOME USE
WARRANTY
The manufacturer warrants this product against defects in materials and
workmanship for a period of ONE (1) YEAR from the date of retail purchase
by the original end-user purchaser (“Warranty Period”).
If there is a defect and a valid claim is received within the Warranty Period,
the defective product can be replaced or repaired in the following ways:
(1) Return the product to the manufacturer for repair or replacement at
manufacturer’s option. Proof of purchase may be required by manufacturer.
(2) Return the product to the retailer where product was purchased for
an exchange (provided that the store is a participating retailer). Returns to
retailer should be made within the time period of the retailer’s return policy
for exchanges only (usually 30 to 90 days after the sale). Proof of purchase
may be required. Please check with the retailer for their specific return
policy regarding returns that are beyond the time set for exchanges.
Summary of Contents for PPRH5B
Page 13: ...12 ...
