9
Troubleshooting
Problem
Possible Cause
Possible solution
• Tool will not charge.
• Charger not plugged into
• Plug charger into a
a working outlet.
working outlet. Refer to
“Important
Charging
Notes”
for
more
details.
• Check current at
receptacle
by
plugging
in
a
lamp
or
other
appliance.
• Check to see if
receptacle is connected to
a
light
switch
which
turns
power
off
when
you
turn
out
the
lights.
• Surrounding air temperature
• Move charger and tool
too hot or too cold.
to a surrounding air
temperature
of
above
40
degree
F
(4,5°C)
or
below
105
degree
F
(+40,5°C).
For assistance with your product, visit our website
www.blackanddecker.com for the
location of the service center nearest you or call the BLACk & DECkER help line at
1-800-544-6986.
BATTery reMOvAl
Before attempting to disassemble this tool, turn it on and run it in either direction until
it stops to ensure a complete discharge of the batteries. Using a phillips screwdriver,
remove the screws from the product housing and take the two body halves apart. Lift
the batteries out and pull off the terminal clips. See “Service Information” for battery
replacement and RBRC for battery recycling.
rBrC seAl
TM
THe rBrC™ seAl
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the costs
to recycle the battery (or battery pack) at the end of its useful life have already
been paid by Black & Decker. In some areas, it is illegal to place spent nickel-
cadmium batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-
cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery, or call
1-800-8-BATTery.
ACCessOries
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
wArNiNG:
The use of any accessory not recommended for use with this tool could
be hazardous.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTe: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
