8
OPerATiNG iNsTrUCTiONs
Prior to operation:
• Make sure your screwdriver is (fully) charged.
swiTCHiNG ON AND Off (fiGUre G)
• To turn the tool ON in a forward direction,
move the
forward/reverse slider (2) upward.
• Squeeze the
trigger switch (1) and the tool
will run.
• Release pressure from the trigger and the
tool will stop.
• To turn the tool ON in a reverse direction,
move the
forward/reverse slider (2)
downward.
• Squeeze the
trigger switch (1) and the tool
will run.
• Release pressure from the trigger and the
tool will stop.
• To lock the tool in the off position, move the
forward/reverse slider (2) to the central position.
leD liGHTs
When the screwdriver is activated by pulling the
trigger switch (1), the integrated light
ring (5) will automatically come on. The light ring will go off when the trigger is released.
sCrewDriviNG
• Insert the appropriate hex shank screwdriver bit.
• Set the
forward/reverse slider (2) to the desired rotation.
DrilliNG
• Insert the appropriate hex shank drill bit.
• Select forward rotation.
GeNerAl DrilliNG TiPs
• This tool is not recommended for drilling in masonry.
• Use sharp drill bits only.
• Drill bits for metal can be used for drilling holes in wood. These bits must be sharp and
should be pulled out frequently when drilling to clear chips from the flutes.
• Support and secure work properly, as instructed in the safety Instructions.
• Use appropriate and required safety equipment, as instructed in the safety
instructions.
• Secure and maintain work area, as instructed in the safety instructions.
• Use light pressure until the hole is started enough to keep the drill bit from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not
so much as to stall the motor or deflect the bit.
• Hold the tool firmly to control its twisting action.
• DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT TO
START IT. DAMAGE TO THE TOOL CAN RESULT. To remove, twist the bit back and forth and
straight out.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through last part of
hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
• Make sure switch turns tool on and off.
wArNiNG: It is important to support work properly and to hold the tool firmly to prevent
loss of control which could cause personal injury.
MAiNTeNANCe
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
iMPOrTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
G
2
1
