reADiNg the BAttery/chArge stAtUs leD iNDicAtor
The battery and charging status LED indicator is located on the back of the unit. It lights or flashes in three
colors to indicate the following:
when charging:
Green:
Battery is in a fully charged state.
Orange (flashing):
Battery is in a partially charged state.
Red (flashing):
Battery needs to be recharged.
Green & Red (flashing alternately):
1. The battery of the unit is overheated due to extensive use or recharging. The charging process will stop at
this stage and will automatically resume after a cool down period.
2. The battery voltage of your vehicle or other 12 volt DC power source has dropped to a level that is too
low when charging using the 12 volt DC adapter. The charging process will stop at this stage and will
automatically resume after the battery level of the 12 volt DC power source returns to normal.
when operating:
Green:
Battery is operating at full voltage.
Orange:
Battery is operating at partial voltage.
Red:
Battery is operating at low voltage, and should be recharged.
chArgiNg/rechArgiNg the sPotlight
This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use using the 120
Volt AC Adapter for 6 hours or until the battery/charge status LED indicator lights green.
Recharge after each use until the battery/charge status LED indicator lights green.
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every 3
to 6 months.
charging/recharging using the 120 Volt Ac Adapter
•
Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
•
Insert the barrel connector of the AC Adapter into the 12 Volt DC Charging Port on the back of the unit. Insert
the plug end into a (powered) standard North American 120 volt 60Hz outlet.
•
Charge until the battery/charge status LED indicator lights green (approximately 6 hours).
charging/recharging using the 12 Volt Dc Adapter (optional accessory)
•
Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
•
Insert the barrel tip of the supplied 12 Volt DC Adapter into the 12 Volt DC Charging Port on the back of the
unit.
•
Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power source.
•
Charge until the battery/charge status LED indicator lights green (approximately 4-6 hours).
Notes:
When using a vehicle’s 12 volt DC accessory outlet as a charging source, be aware that some vehicles require you to turn on the
ignition to power the accessory outlet.
WARNING:TO AVOID THE RISK OF PROPERTY DAMAGE:
•
NEVER CONNECT THE UNIT TO A POSITIVE GROUNDED VEHICLE.
•
The 12 Volt DC Adapter must only be connected to batteries with a nominal output voltage of 12 volts. The
unit will not operate from a 6 volt battery and will sustain permanent damage if connected to a 24 volt battery.
oPerAtiNg iNstrUctioNs
operating the spotlight
1. Disconnect from charger.
2. The On/Off trigger is located in the front of the handle of the spotlight.
3. To turn the spotlight on, squeeze the trigger.
4. To turn off the spotlight, release the trigger.
Note:
The On/Off trigger can be locked in the on position using the trigger lock bar on the side of the unit.
The battery/charge status LED indicator will light in one of three colors (as described in the “Reading the Battery/Charge Status LED
Indicator” section) to indicate the battery status.
•
Charge after each use.
•
Always charge at least once every 3-6 months if not in frequent use to prevent overdischarge.
transportation of lithium-ion Batteries
•
Always check all applicable local, national, and international regulations before transporting a unit containing a
Lithium-Ion battery.
•
Transporting an end-of-life, damaged, or recalled battery may, in certain cases, be specifically limited or
prohibited.
SAVE thESE inStRuctionS
iNtroDUctioN
Congratulations on purchasing your new
Black & Decker Lithium-Ion LED Spotlight
.
Read this
Instruction Manual and follow the instructions carefully before using your new spotlight.
FeAtUres
1
5
6
10
11
9
4
8
2
3
1. Light Mode Select Button
2. 12VDC Charging Port (under protective cover)
3. Battery/Charge Status LED Indicator
4. Pistol Grip Handle
5. On/Off Trigger
6. Rubber Bezel
7. Locking Adjustable Stand
8. Aluminum heat sink
9. Trigger Lock
10. 120 Volt AC Adapter
11. 12 Volt DC Adapter (optional accessory)
