Black & Decker EK30, Manual

Page: 4 / 32

4
ENGLISH
X
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
X
Before use, check the power supply
cord for signs of damage, ageing and
wear.
X
Do not use the appliance if the power
supply cord or mains plug is damaged
or defective.
X
If the power supply cord or mains plug
is damaged or defective it must be
repaired by an authorised repair agent
in order to avoid a hazard. Do not cut
the power supply cord and do not
attempt to repair it yourself.
X
Never attempt to remove or replace
any parts other than those specified in
this manual.
Warning symbols
The following symbols are used in this
manual:
Denotes risk of personal
injury or damage to the
product in case of non-
observance of the instructions
in this manual.
Denotes risk of electric shock.
Electrical safety
This tool is double insulated
in accordance with EN 60335;
therefore no earth wire is
required. Always check that
the power supply corresponds
to the voltage on the rating
plate.
To avoid the risk of electric
shock, do not immerse the
cord, plug or motor unit in
water or other liquid.
Features
This appliance includes some or all of the
following features:
1.
On/off switch
2. Knife handle
3. Blade release button
4. Slots
5. Guard
6. Fine-tooth blade
7. Coarse-tooth blade
8. Blade sheath
9. Rivet
Assembly
Warning!
Make sure that the appliance is
switched off and unplugged.
Interlocking the blades (fig. B and C)
The blades must be locked together
before they are inserted into the knife
handle.
X
Hold the ends of the blade shafts
behind the guard (5) and slip the rivet
(9) on the tip of the rear blade through
the hole in the other blade.
X
Slide the rivet forward in the slot.
X
Bring the blades together making sure
that the tips remain locked.
X
Slide the blade sheath (8), over the
assembled blades.
X
Only use the appliance with two
interlocked blades.
Inserting the blades into the handle
(fig. A)
Warning! Switch off the appliance before
changing accessories or approaching parts
which move in use
Warning! Do not plug in the appliance
before the blades are correctly inserted into
the knife handle.
X
Make sure that the blades (6 or 7) are
correctly interlocked and the blade
sheath (8) is fitted over the blades.
X
Hold the assembled blades by the
guard (5).
X
Slide the blade shafts into the slots (4)
in the knife handle (2). Make sure that
the blades click into place.
!