Page 9
3. Attach REINFORCING BARS to the top and bottom of the left BACK pole and the
top of the LF1-1 as shown below.
Attach one side of a REINFORCING BAR to
LB2-1
. Align the holes and Insert 45L
(BUTTERFLY SCREW) through
LB2-1
first and then through the reinforcing bar.
Attach one side of a REINFORCING BAR to LF1-1 . Align the holes and Insert 45L
(BUTTERFLY SCREW) through LF1-1 first and then through the reinforcing bar.
Attach one side of the remaining REINFORCING BAR to LB2-2
. Align the holes
and Insert 45L (BUTTERFLY SCREW) through LB2-2 first and then through the
reinforcing bar.
SET UP & USE
REINFORCING BAR
REINFORCING BAR
45L
45L
LB2-1
LB2-2
LF1-1
NOTE:
The wings of 45L screw must keep vertical rather than horizontal so it does
not obstruct the installation of the DRYER SUPPORT.
45L
CORRECT
INCORRECT
