JXG4604SS
Owner’s Manual
16
FIG. A FIG. B FIG. C
Burner Installation and adjustment
Lighting Infrared/Searing Side Burner
1. Open lid while lighting burner.
2. Make sure the control knob is locked in the “OFF” position.
3. Open cylinder valve.
4. Push and turn control knob to “HIGH” setting. After lighting, please observe the ceramic plate on the surface of burner; it
should feel warm after 5-10 seconds and the color of the ceramic plate should turn red in 2-3 minutes.
5. If burner does not light on the first try, turn the control knob to its OFF position and wait 5 minutes for gas to clear before
trying again. If burner flame goes out during operation, immediately turn the gas OFF and open lid to let the gas clear for
about 5 minutes. Attempt to re-light.
6. Clean your grill after each use, DO NOT use abrasive or flammable cleansers, as it will damage the parts of this product and
may start a fire. Clean with warm soapy water.
Observing the Heat and Color of the Infrared Ceramic Burner when lit
● Flame of infrared burner
might be visible in shaded area.
● After burner is lit, it should feel warm i
n 5-10 seconds and color of the ceramic plate turns red in approximately 2-3 minutes.
WARNING:
DO NOT adjust the air-shutter while the grill is in operation. If it still hot, please wear protective gear and be careful. Failure to follow
this instruction could cause personal injury.
Flare-ups
“Flare-ups” sometimes occur when food drippings fall onto the hot heat distribution plate or the burners and will ignite. Some flaring is
normal and desirable as it helps impart the unique flavors associated with grilled foods. Controlling the intensity of the flare-ups is
necessary, however, in order to avoid burned or unevenly cooked foods and to prevent the possibility of accidental fire.
WARNING: Always monitor the grill closely when cooking and turn the flame level down to “LOW” or “OFF” if flare-ups
intensify.
Normal: Soft blue flames with yellow tips
between I inch - 2 inches high.
Out of adjustment: Noisy hard blue
flames – too much air.
Poor combustion: Wavy, yellow
flames- too little air.
1. Release the screw on venturi tube.
2. Adjust the flame by turning the collar on head of
venturi tube from back side of the grill and do
not take apart the venturi tube.
3. Tighten the screw and make certain it is
secured.
1. Overlap 14 mm between
venturi tube and nozzle
when assembling.
2. Keep the center line of
venturi tube and nozzle on
one line.
1. Place edge face up to install the
burner.
