JXG4604SS
Owner’s Manual
15
WARNING
: Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no obstructions
of airflow to the gas unit. Spiders and insects can nest and clog the burner/ venturi tube at the orifice.
A clogged burner tube can lead to a fire beneath the appliance.
2. All valves must be in the “OFF” position.
3. Open cylinder valve.
4. Ignite only the burners you wish to use, using the same method for each:
Push desired burner valve knob and rotate slowly about 1/4 counterclockwise until a click is heard.
The burner should light. If the burner does not light, return the valve knob to the “OFF” position immediately.
Wait five minutes for the gas to clear and repeat the procedure. After burner is lit, repeat the procedure with any other burner
desired.
5. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Insert a match into the end of lighting stick. Light the match.
2. Once lit, put the lighting stick through the cooking grid and place the flame next to
the burner ports found along the sides of the desired burner (See diagram to right.)
3. Press the valve knob and rotate it counter-clockwise to the ‘’HIGH’’
position. The burner should light immediately. If more than one burner
is desired, repeat the procedure 2-3 until all desired burners are lit.
4. Adjust burners to the desired cooking temperature.
Precautions
1. After lighting, observe the burner flame. Make sure all burner ports are lit.
2. If the burner flame goes out during operation, immediately turn the gas “OFF”.
Open lid to let the gas clear for at least 5 minutes before re-lighting.
3. Before cooking on the grill for the first time and operate the grill for approximately 15 minutes with the lid closed and the gas
turned on “HIGH”. This will “heat clean” the internal parts, dissipate odor from the manufacturing process and painted finish.
4. Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and cause a
fire.
Side Burner
1. Open lid while lighting the burner. Lid must remain open while burner is lit.
2. Valve must be in the “OFF” position.
3. Open cylinder valve.
4. Push side burner knob fully and rotate it slowly about 1/4 turn counterclockwise until a click is heard. The burner should light.
If the burner does not light, turn the knob to the “OFF” position immediately. Wait five minutes for the gas to clear and repeat
the procedure.
5. Adjust valve knob to the desired cooking temperature
Using the Lighting Stick to Light the Side Burner
1. Open lid while lighting the burner. Lid must remain open while burner is lit
2. Remove the lighting stick then insert a match into the end of lighting stick.
Light the match.
3. Once lit, place the flame to reach the burner ports. (See diagram to right.)
4. Press the control knob and rotate it counterclockwise to the ‘’HIGH’’
position. The burner should light immediately.
5. Adjust burner to the desired cooking temperature.
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A,B
and C below for the proper flame patterns). If the flame pattern is other than normal, consult
the
Troubleshooting
on page 19 for corrective action.
Observe flame height when lit:
Flame should be a blue/yellow color between 1 to 2 inches high.
2 in.
1 in.
0 in.
