Rev. 1.00
- 18 -
SRP-Q300/302
2. Self-Test
• The self-test checks whether the printer has any problems. If the printer does not function
properly, contact your dealer. The self-test procedure is as follows:
1) Make sure paper roll has been installed properly.
2) Turn on the power while holding down the FEED button and the self-test begins.
3) The self-test prints the current status of the printer including control ROM version.
4) After printing the current printer status, the printer wait for the next step after printing the
following lines. (The paper signal light keeps blinking.)
SELF-TEST PRINTING.
Select a button to run the following.
Continue test printing : Press the button briefly
Memory switch configuration mode : Press and hold down button
5) Press the Feed button to resume printing or hold down the button for at least one
second to change the VMSM settings.
• If “Continuous SELF-TEST” is selected
(1) Press the Feed button for less than one second to print the preset page.
(2) The self test ends automatically as it prints the following line and cuts the paper
*** COMPLETED ***
(3) The printer goes into normal print mode upon completion of the self test.
