Rev. 1.01
- 48 -
SMP6210
8-3-3 Parallel design of the platen roller block
When the platen roller block is mounted on the printer mechanism, two blocks must be
aligned to be parallel. Otherwise it might cause cutting failure and reduce life of cutter.
Check performance after installation.
The degree of parallel alignment must be within -1
~ +1
.
8-3-4 Mounting platen roller block
Fig 8-5 dimension drawing shows the position and usage of holes to mount the platen
roller block on the pivot system of the outer case.
The dimensions of 14.6 mm and 10.1 mm in the picture that determine the mounting
position of the platen roller block are important numbers that define the mounting
performance of platen roller block and cutting status, and these dimensions must be
controlled exactly as shown in the picture when designing the outer case. Incorrect
dimensions may cause serious problems such as incomplete cutting or partial cutting.
Fig 8-5 Dimensions related to the mounting of the platen roller block
-
Holes at ‘a 2’ positions are for setting the position of the platen roller block, design the
boss for these two holes. The size and heig
ht of the boss shall be within Φ2, and1.2mm
respectively.
-
Holes at ‘b 3’ positions are for fixing the platen roller block using screws.
※
Recommended screws specifications: M2.6 x 4 Tapping Screws
Summary of Contents for SMP6210
