Rev. 1.00
- 25 -
SLP-T400IIx/T403IIx
5-5 Smart Media Detection
• Printer executes this function when necessary without user input and media
configuration can be completed with Smart Media Detection function for most print
papers.
• Papers with gap and black mark can be identified without separate settings.
• 3 ~ 5 pages of labels will be used depending on the type of paper.
• Smart Media Detection function is executed in the followings cases
- When the printer is installed first time, it is executed through Feed button or print
command.
- When change paper length is detected during feeding or printing.
- When the paper type entered by command is different from the configured paper type.
- After reset with factory settings
• Smart Media Detection function will be turned off after setting the sensor sensitivity using
Automatic Calibration Mode or Manual Media Calibration mode, and it will be enabled
again after resetting the printer with factory settings.
5-6 Auto Calibration Mode 1
Use this mode when paper is not detected correctly with Smart Media Detection function.
Paper type (gap or black mark) is identified automatically.
The printer will enter error mode if paper detection fails after feeding up to 1 meter of paper.
Error mode can be released by opening and closing the cover.
Use Automatic Calibration Mode 2 or Manual Calibration Mode if paper detection fails in
this mode.
5-6-1 Procedure to run the calibration
1) Check whether paper is installed correctly
2) Turn off the power.
3) Turn on the power while depressing the Pause button and Feed button simultaneously.
4) Release the buttons when both LEDs change to orange color in about five seconds.
LED1 will change to green and LED2 will change to red.
5) Depress the Pause button to go back to Print Standby Mode without setting the paper.
6) Depress the Feed button to start Smart Media Detection.
7) The printer will enter Print Standby Mode automatically if there is no button input for
three seconds.
