BITREK BI-530C TREK, Operating Manual

Page: 24 / 59

24
www.bitrek.eu
sales@bitrek.eu
+372 880 78 78
Configuring the device for working with tires pressure
sensors via RS-232
«BI 530С TREK» tracking device has the ability to work with tires
pressure sensors (CUB TPMS) via RS-232 interface. In total, up to 23
sensors can be connected simultaneously. The tracker can collect and
transmit information about the current value of pressure and air
temperature for each of the sensors to the server. A list of all available
I/O-elements for working with pressure sensors is provided in Appendix
5 .
To enable work with pressure sensors it is necessary to set the
appropriate mode of operation for RS-232. To do this, send the
command:
setparam 5007 5;
Receiver connector pinout is discribed at Figure.8.
Figure 8. CUB receiver connector pinout
No.
Contact
name
Signal type Description
1 TX Input/output Signal «TX» RS-232
2 RX Input/output Signal «RX» RS-232
3 N\C - Not connected
4 GND Power Common wire (ground)
Configuring the device for working with the LP Speed
Limiter
«BI 530С TREK» tracking device has the ability to work with the LP
Speed Limiter device via RS-232 interface. This device allows you to set
the boundary limit of the vehicle speed.
To work with this device, you must switch the operating mode of
the RS-232 interface of the tracker to the value 4:
setparam 5007 4;