9
Tip:
A spec ial red
float devic e in
the tank will
c ause the
c leaner to
stop removing
solution from
the c arpet and
the motor sound
will rise in pitc h
to let you know
the dirty water
tank is full.
The Flow Indic ator
This is located on the m achine base. It spins when
the trigger is pressed to indicate that the m achine
is applying cleaning solution to the floor. It will
stop spinning to indicate that the Sm artMix
®
Bottle or bladder needs to be refilled, or when
the trigger is released.
ReadyTools
™
Switc h
This provides above floor cleaning with the
flip of a switch. Just choose the cleaning
tool, attach to the flex hose and
POWERSTEAMER
®
PROHEAT
™
PLUS is ready to clean
upholstery and m ore.*
* Set the switch to
Floor
Clean in g
when
clea n in g ca rpets or
b a re floors or set it
to
Tools/PreTreat
when u sin g the flex hose
a tta chm en ts or for pre-trea tin g floors.
* Sm a rtTem p
™
hea ts the clea n in g solu tion for
ca rpet a n d b a re floor a pplica tion on ly. It d oes n ot
hea t solu tion spra yed throu gh the a ccessory tools.
When You’re Done
1. Disconnect the TurboBrush
™
from
the vacuum flex hose by pushing
down on the button lock and
pulling straight off.
2. Once rem oved from the flex hose, the
TurboBrush
™
can be cleaned:
1. Move the switch to the
“SUCTION” position.
2. Rinse under running water.
3. Check spray nozzle for dirt.
If necessary, clean with soft
bristle brush.
4. Replace TurboBrush
™
in its
special storage location on the
handle front.
Assembly
Unplug before attaching the TurboBrush.
™
Attach
TurboBrush
™
to the flex hose by pressing tool onto the
grip/trigger until button snaps into hole.
Make certain tool is securely in place.
Use
1. Move the TurboBrush
™
switch to the “BRUSH” position.
This activates the brush.
2. Place the tool directly on the soiled surface.
Apply downward pressure on the tool and
pull towards you while pulling trigger to
spray cleaning solution.
3. Release the spray trigger and m ove the
switch to the “SUCTION” position.
Vacuum the area until no m ore cleaning
solution can be rem oved.
4. Repeat steps 1-3 until no m ore dirt can be rem oved.
Cau tion : Do n ot overwet.
How to use Tur boBr ush
™
attachment
Flow Indic ator
ReadyTools
™
Switc h
