10
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
3
3
4
Check rotating floor brush and drive belt
You should check your vacuum cleaner’s
rotating floor brush and drive belt regularly
for wear or damage. You should also clean
the brush and brush ends of strings, hair
and carpet fibers. This type of debris can
wrap around the brush and hamper its
ability to effectively clean your carpet. Also
remove any debris that has accumulated
under the brush cover.
1.
Unplug the vacuum from electrical outlet.
2.
Place handle in low position and turn vacuum
cleaner over so bottom side is facing up.
3.
Remove the five screws in the brush cover
as shown. Lift off the brush cover.
4.
Grasp rotating floor brush at both ends and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6.
Clean strings, hair and other debris from
motor pulley and drive belt areas.
7.
Check drive belt carefully for wear, cuts, or
stressed areas.
8.
Check air passageway for obstructions.
Remove debris from this area.
9.
When finished cleaning, reposition floor
brush and drive belt. Replace the brush
cover and secure with all five screws.
M
aintenance and care
WARNING:
To reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect Power Plug
from electrical outlet.
