12
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Clearing Clogs
Low suction or poor pickup may be due to
a clog in the vacuum cleaner. If you notice
a change in the sound of the motor, check
for clogs.
1.
Turn power switch off. Unplug cleaner from
electrical outlet.
2.
Empty dirt container.
3.
Check upper tank for build up or clogs.
4.
If you notice a clog in the upper tank,
remove the inner cyclone (see section
“cleaning the upper tank” on page xx.)
5.
Grasp the hose and separate it from the
hose wand base. Check for a clog in the
base or in the hose itself.
6.
Remove the Twist ‘n Snap hose from the
vacuum by turning to the left. Straighten the
hose and unclog with a long, narrow object
such as a broom handle.
7.
If the clog persists, follow the instructions
for “checking the rotating floor brush and
drive belt” on page xx and inspect the
passageway for obstructions.
Cleaning the upper tank
1.
Grasp the inner cyclone and twist to the left
until the locking tabs stop the rotation. Pull
down from the upper tank to remove it.
2.
Wipe out the inside of the upper tank and the
inner cyclone with a damp cloth moistened
with water or a mild cleaning solution.
3.
The inner cyclone may be washed using a
mild detergent. Be sure it is completely dry
before reassembling or damage to your unit
may result.
4.
Once cleaning is complete, replace the inner
cyclone by sliding it into the upper housing.
Line up the inner cyclone by ensuring the
tabs on the cyclone are positioned toward
the front of the unit. Push the inner cyclone
in and rotate it to the right until the locking
tabs stop the rotation.
CAUTION:
To reduce the risk of injury
from moving parts, turn off
vacuum cleaner and dis-
connect power plug from
electrical outlet.
2
4
