Vacuum cleaner won’t pick up dirt continued
Possible Causes
Remedies
Dirt Container not installed properly
Position correctly and lock in place
Filters are dirty
Check and clean Inner and Outer
Circular Filters, Pre-Motor and
Post-Motor Filters
Louvers missing or installed incorrectly
Check for a clog in the tube in the
center of the Dirt Container, clear
and properly install Louvers
Tools won't pick up dirt
Possible Cause
Remedies
Crack or hole in Hose
Check Hose and replace if needed
Clog in vacuum
Clear clog, see pg. 11-12
Dirt Container full
Empty Dirt Container
Dirt Container or Upper Tank
Position correctly and
not installed properly
lock in place
Filters are dirty
Check and clean Inner and Outer
Circular filters, Pre-Motor and
Post-Motor Filters
Louver missing or installed incorrectly
Check for a clog in the tube in the
center of the Dirt Container, clear
and properly install Louvers
Vacuum cleaner is difficult to push
Possible Causes
Remedies
Incorrect Height Adjustment
Adjust Powerfoot to correct
height setting
Brush Cover installed incorrectly
Make sure all four screws are in
place or all three latches are secured
Visible dirt escaping from cleaner
Possible Causes
Remedies
Dirt Container full
Empty Dirt Container
Filters missing or installed incorrectly
Check Inner and Outer Circular
Filters and Post-Motor Filter for
correct installation
Dirt Container installed incorrectly
Pull out and re-insert Dirt
Container correctly
Filter Cup installed incorrectly
Remove Dirt Container and make
sure Filter Cup is fully attached
If suggested solutions do not correct the problem, call:
BISSELL Consumer Services
Troubleshooting Continued
13
3
3
4
4
5
5
6
6
1
1
1
1
2
2
3
3
2
2
4
4
10
10
11
11
12
12
1
1
2
2
