5
How To Put It Together
Select Models Only
The only tool you’ll need to assemble your vacuum
cleaner is a screwdriver.
Locate the vacuum Handle and remove the screw
packet taped to the base of the Handle.
Stand the vacuum upright and slide the base of
the Handle firmly into the grooves at the top of the
vacuum body.
Check to be sure the Handle is fitted to the vacuum
body. If there is a gap in front, continue to push firmly
until the Handle is flush.
Insert the screw provided from the screw packet into the
existing hole. Tighten securely with a screwdriver.
Attach the Twist ‘n Snap™ Hose by lining up the tabs on
the base with the corresponding notches on the back of
the vacuum as shown.
Turn the Twist ‘n Snap Hose to the right to lock the hose
into place.
Snap Hose Clip onto Upper Handle (select models only).
Grasping the Quick Reach Handle, slide the end of the
Hose Wand onto the Hose Wand Base. Snap the Hose
into the Hose Clip.
nOTE: The Powerfoot will not operate
effectively unless the Hose Wand is
firmly attached.
Snap the Extension Wand and the Crevice Tool together
into the storage clip as shown.
Snap the Combination Tool into the storage clip as shown.
Attach the TurboBrush
®
by aligning the small holes near the
brush roll with the tabs at the bottom of TurboBrush housing.
Snap TurboBrush into place as shown.
1.
Attach Handle To Vacuum
2.
3.
4.
Attach Vacuum Hose and Tools
1.
2.
3.
4.
5.
6.
7.
