To maintain maximum cleaning performance, the
following maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the
“Full” line on the side.
Check the Inner and Outer Circular Filters and the
Pre-Motor Filter at least once a month and clean or
replace as needed.
Replace the Post-Motor Filter every three to six months.
note: More frequent filter cleaning or
replacing may be necessary if you are
vacuuming new carpet, fine dust, or have
allergy concerns. Follow the instructions on
the following pages to perform these simple
maintenance steps.
The Dirt Container needs to be emptied when the dirt
reaches the “Full” line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to
remove from vacuum.
Empty dirt into garbage container.
Put the Dirt Container back in the vacuum and slide the
lever to the "Lock" position.
note: The Dirt Container may be washed in
warm water with a mild detergent. Remove
the Filter Cup from the bottom before
washing. Reassemble and make sure it is
completely dry before using again.
Use only BISSELL Style 9 Replacement Filters in
your BISSELL CleanView II.
Unplug the cleaner from electrical outlet.
Remove the Dirt Container as described in the previous
section. Grasp the Filter Cup located at the bottom of
the Dirt Container and twist counterclockwise to unlock
and remove.
Grasp the Circular Filters and twist to unlock. Pull
straight up to remove.
8
How To Maintain your Vacuum
1.
2.
3.
Empty Dirt Container
1.
2.
3.
4.
5.
Tip:
For maximum cleaning
performance, check
and clean or replace all
filters as suggested.
WARnInG:
To reduce the risk of
electric shock, turn Power
Switch OFF and discon-
nect polarized
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
Full Line
Lock Position
Unlock
Position
Cleaning The Inner & Outer Circular Filters
1.
2.
3.
