Practice
1. Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges.
2. Turn the pressure control knob counterclockwise to its to its lowest setting.
3. Turn the PRIME/SPRAY valve up to its SPRAY position.
4. Turn the pressure control knob clockwise to its highest setting. The paint hose should stiffen as paint begins to flow through it.
5. Unlock the gun trigger lock.
6. Trigger the spray gun to bleed air out of the hose. 7.When paint reaches the spray tip, spray a test area to check the spray pattern.
8. Use the lowest pressure setting necessary to get a good spray pattern. If the pressure is set too high, the spray pattern will be too
light. If the pressure is set too low, tailing will appear or the paint will spatter out in gobs rather than in a fine spray.
Cleanup
Special cleanup instructions for use with flammable solvents:
always flush spray gun preferably outside and at least one hose length from spray pump.
If collecting flushed solvents in a one gallon metal container, place it into an empty five gallon container, then flush solvents.
Area must be free of flammable vapors. Follow all cleanup instructions.
The sprayer, hose, and gun should be cleaned thoroughly after daily use. Failure to do so permits material to build up, seriously
affecting the performance of the unit.
Always spray at minimum pressure with the gun nozzle tip removed when using mineral spirits or any other solvent to clean the
sprayer, hose, or gun. Static electricity buildup may result in a fire or explosion in the presence of flammable vapors.
1. Follow the “Pressure Relief Procedure”found in the Operation section of this manual.
2. Remove the gun tip and tip guard and clean with a brush using the appropriate solvent.
3. Place the suction tube into a container of the appropriate solvent. Examples of the appropriate solvent are water for latex paint or
mineral spirits for oil-based paints.
4. Place the return hose into a metal waste container.
5.Move the PRIME/SPRAY valve down to its PRIME position.
6.Set the pressure to Turbo Pulse Clean by turning the pressure control knob to its CLEAN position 7.Turn the unit on by moving the
ON/OFF switch to the ON position.
8. Allow the solvent to circulate through the unit and flush the paint out of the return hose into the metal waste container.
9. Turn the unit off by moving the ON/OFF switch to the OFF position.
10. Move the PRIME/SPRAY valve up to its SPRAY position.
11. Turn the unit on.
Ground the gun by holding it against the edge of the metal container while flushing. Failure to do so may lead to a static electric
discharge, which may cause a fire.
12. Trigger the gun into the metal waste container until the paint is flushed out of the hose and solvent is coming out of the gun.
13. Continue to trigger the spray gun into the waste container until the solvent coming out of the gun is clean.
NOTE:For long-term or cold weather storage, pump mineral sprits through the entire system. For
short-termstorage when using latex paint, pump water mixed with Titan Liquid Shield through the
entire system (see the Accessories section of this manual for part number).
14. Follow the ¡°Pressure Relief Procedure¡± found in the Operation section of this manual.
15. Unplug the unit and store in a clean, dry area.
Do not store the unit under pressure.
www.italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
www.italiastar.ro
004/021.433.03.27
90
