Earthing Instructions
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing
an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding
plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
Operation
This equipment produces a fluid stream at extremely high pressure.
Read and understand the warnings in the Safety Precautions section at the front of this manual before operating this equipment.
Setup
Perform the following procedure before plugging in the power cord of an electric unit.
1. Ensure that the suction set and the return hose are attached and secure.
2. Using a wrench, attach a minimum of 50’ of 1/4” nylon airless spray hose to the unit. Tighten securely. 3.Attach an airless spray gun
to the spray hose.
Using two wrenches (one on the gun and one on the hose), tighten securely.
NOTE:Do not attach the tip to the spray gun yet. Remove the tip if it is already attached.
Make sure all airless hoses and spray guns are electrically grounded and rated for at least 3200 psi (220 bar) fluid pressure.
4. Make sure the pressure control knob is in its OFF position in the black zone.
5. Make sure the ON/OFF switch is in its OFF position. 6.Fill the oil cup with one tablespoon of piston seal lubricant (Piston Lube).
Never operate unit for more than ten seconds without fluid. Operating this unit without fluid will cause unnecessary wear to the
packings.
7.Make sure the electrical service is 220V/50HZ 8.Plug the power cord into a properly grounded outlet at least 25’ from the spray
area.
Always use a minimum 12 gauge, three-wire extension cord witha grounded plug. Never remove the third prong or use an adapter.
Preparing a New Sprayer
If this unit is new, it is shipped with test fluid in the fluid section to prevent corrosion during shipment and storage. This fluid must be
thoroughly cleaned out of the system with mineral spirits before you begin spraying.
Always keep the trigger lock on the spray gun in the locked position while preparing the system.
1.Place the suction tube into a container of mineral spirits.
2.Place the return hose into a metal waste container. 3.Set the pressure to minimum by turning the pressure control knob to the”Min”
setting
(clockwise -- increased working pressure)
4.Move the PRIME/SPRAY valve down to the PRIME Position.
www.italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
www.italiastar.ro
004/021.433.03.27
86
