Page 5
Section 2
Commissioning and Startup
2.1 Prerequisites (Specific System Requirements on Site)
A “Static IP Address” and a “Subnet Mask” (please contact your IT department
for details).
A “Default Gateway IP Address” (please contact your IT department for details).
2.2 Initial Configuration of the Network Control Unit
The initial connection to the BNCU requires you to connect your laptop/PC to
the BNCU. Using the 10m Ethernet cable supplied (or any Ethernet available on
site)
, connect one end of the cable to the “ETH” port on the BioTector as shown
in the picture above and connect the other end of the cable to the Ethernet port
of your laptop/PC.
You need to temporarily change the TCP/IP configuration of your network
adapter. Carry out the following steps in your laptop/PC:
1) Using the Start button, go to Control Panel
Network and Internet
Network & Sharing Centre
as shown in the picture below.
2) In the opened window, select
Change Adapter Settings
as shown in
the picture above.
3) Right-click on
Local Area Connection
and select
Properties.
