Operation Manual for Oscillating Dry Bath Important Notes
—
III
—
must be replaced but not be repaired. The replacement shall be carried out with the power line of the
same type and same specification. No goods shall be put on the power line when the instrument is
working and please do not put it in a frequently-visited place.
e) The plugging in and removing of the power line
The user should hold the plug to remove the power line. When plugging in the plug, the user
should make sure that it has been fully plugged in; when removing the plug, do not pull the power line
forcefully.
f) Placement of the instrument
This instrument shall be fixed in a low RH and low dust place apart from water source (e.g. water
pool and water pipeline) and the room shall be well ventilated, and free of corrosive gas and
interference of strong magnetic field. The instrument shall not be placed in a wet or dusty location.
The openings on this instrument are for ventilation circulation and in order to avoid over-heat of
the instrument body, they shall not be blocked or covered. When a single set of instrument is used, the
interval between ventilation openings before and after the instrument and the nearest object shall not
be less than 25cm. Also, don’t use the instrument on loose or soft surface, or the air inlet at instrument
bottom might be blocked.
Excessive temperature would impair the test performance or result in fault of instrument. This
instrument shall not be used in location subjected to direct sunshine. The instrument shall be kept away
from hot gas, stove and all other heat sources.
If the instrument is to be set aside for a long time, the power plug shall be withdrawn and the
instrument covered with soft cloth or plastic film to avoid entrance of dust.
Caution:
In any of the following cases, immediately cut off the power supply, withdraw the
power plug from the power socket, and contact the supplier for treatment:
Liquid drops into the inside of the instrument;
The instrument is rained or watered;
The instrument works abnormally, especially generates abnormal sound or
odor;
The instrument is dropped or its casing is damaged;
The function of instrument obviously changes.
g) Warning sign
Warning!
There is a sign of “HOT SURFACE” on the instrument. The metal part (module)
near the sign shall not be touched with any part of the body when the instrument is
operating in a high temperature state or just finishes this operation to avoid scald!
3. Module Installation and Instrument Maintenance
The instrument module is not fixed by screws. At the time of installation, the bevel at the left