biodex 950-385, Application/Operation Manual

Page: 6 / 55

Figure 3.1. Attaching the Safety Lanyard, printer cable and printer.
Included with the Gait Trainer 2 are a printer, printer stand and Safety Lanyard. These should all
be attached/installed prior to operation of the Gait Trainer 2.
CONNECTING THE PRINTER
(See Figure 3.1.)
The printer cable should be connected to the printer receptacle at the back of the display with the
USB cable end. Attach the opposite end of the cable to the back of the printer. The cord should run
down the back of the display and over the motor cover so as not to be in contact with the moving
belt. Place the printer on the printer stand. Ensure that the printer stand is positioned next to the Gait
Trainer 2 but far enough away so as not to come in contact with the Gait Trainer 2’s moving parts.
Note: The printer receptacle is for the printer only. Do not plug anything else in this receptacle.
Nota: La prose pour imprimante est destinée à la seule imprimante. Ne brancher rien d’autre dans cette prise.
CONNECTING THE SAFETY LANYARD
(See Figure 3.1.)
A Safety Lanyard is provided. The Gait Trainer 2 will not operate unless the lanyard is attached.
Attach the Safety Lanyard at the left corner of the top cross bar supporting the Display panel. The
round end of the Safety Lanyard attaches to the unit via a Velcro® brand hook and loop fastener.
The clip end of the lanyard should be attached to the patient’s clothing or wrist in a way that does
not interfere with the patient’s exercise.
NOTE: Disconnecting the Safety Lanyard (left side of Display/Control Panel) or pressing the red Safety
Stop (atop the right side of the Support Bar) at any time will cause the treadbelt to immediately ramp down
to a full stop and reset to 0.0 mph. The Display will read <Safety Lanyard Removed> and the treadbelt will
not restart until the Safety Lanyard is once again in position and/or <Start> is pressed following use of the
Safety Stop. Display data is not lost in either case. Data accumulation will resume once the lanyard is recon-
nected and <Start> has been pressed.
Attach Safety Lanyard
Attach Printer Cable
(behind display)
3. SET-UP
— 3-1 — SET-UP