Getting Started
2-6
Step 2:
Check to ensure that the correct com port is selected.
You can test the COM port to see if it is connected and
communicating correctly by clicking on
Test.
If the FL600
is switched on and connected correctly, you will see the
following dialog box appear:
Figure 2-4: Plate Model Information Window
NOTE: You will see an error message if any of the following conditions exist: the
FL600 is not correctly connected; it is not switched on; the incorrect
communications port is selected; there is a cable problem. Check that
the reader is switched on and correctly connected to the computer, that
you have selected the correct communications port, and that the cable is
operational. Then close the message window and try the
test
again.
Click on
OK
to close the dialog box. You will return to the
communications port information dialog box.
Click on
OK
to save the selected communications port, if
you’ve changed it.
NOTE: If you select
Cancel
, the communications window will close without
recording any changes.
