Customer/Warranty Service: 800-595-9605
Page 13
Turning Power On
Press the POWER button on the left side of the Control Panel. The heater‖s quartz heating
elements will light up inside the heater. After a few minutes, once the air within the heater is
warm, the heater fan will begin to operate.
Turning Power Off
Press the POWER button located on the left side of the Control Panel. The sound of the heater
fan will continue until the heat has been completely vented, thus protecting the unit and
preventing waste by cycling the remaining heat into the room. (NOTE: DO NOT unplug the
heater until the sound of the fan has stopped. Doing so may cause damage to the unit.)
Setting the Temperature
This feature allows you to set the temperature your heater will maintain.
1. Press the temperature (TEMP) button on the Control Panel; the SET TEMP indicator will
illuminate and the temperature display will flash.
2. Use the UP and DOWN buttons to select the temperature and press Enter.
3. The SET TEMP light will turn off, and the temperature is now set.
Setting the Timer
This feature allows you to set a future time for the heater to turn itself on. For example, if you set
the time for 1 hour, the heater will turn on in 1 hour.
1. Turn the power off (heater must be powered off to use the timer feature).
2. Press the TIME button on the Control Panel—the two zeros to the right will flash (:00),
indicating 0 minutes have been set, and the DELAY START indicator will illuminate.
3. Press the UP or DOWN button to select desired number of minutes (up to 59 minutes) that
you would like the heater to wait to turn itself on.
4. Press the ENTER button—the two zero buttons to the left will flash (00:), indicating 0 hours
have been set.
5. Press the UP or DOWN button to the desired number of hours (up to 24 hours), and then
press the ENTER button.
6. DELAY START indicator will flash until the unit comes on after waiting the period of time
you have set.
To cancel the timer, press the power button and the timer will stop.
Switching Between Fahrenheit & Celsius
Press the DOWN & ENTER buttons simultaneously and hold for about 3 seconds. The display
will update automatically.
Operating Instructions at a Glance:
