©2011 BioSmart Technologies
Page 10
WARNING
IMPROPER USE OF THIS HEATER COULD RESULT IN RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING
ANY REQUIRED SERVICE OTHER THAN FILTER MAINTENANCE SHOULD
ONLY BE PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE
CAUTION: RISK OF ELECTRICAL SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
DO NOT plug heater into any other cord connected device such as power strip, surge protector, multiple outlet
adapter, grounding adapter, outlet-type air fresheners or extension cords. Plug into a 3-prong 120V 15 amp or
higher grounded circuit receptacle only.
DO NOT plug the heater into a loose fitting or broken receptacle.
DO NOT alter the heater‖s design, or you will void the warranty.
DO NOT block the front or rear of the heater.
DO NOT place anything directly in front of the heater.
DO NOT cover the unit as this may block airflow and cause the heater to malfunction.
DO NOT use the heater outdoors or for heating construction sites.
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater
where it may fall into a bathtub or other water container.
DO NOT force the filter to dry using any alternative methods when performing filter maintenance; doing so
could damage the filter.
DO NOT run cord under carpeting.
DO NOT cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and
where it will not be tripped over.
DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock or fire, or damage the heater.
Heater has hot and arcing or sparking parts inside. DO NOT use it in areas where gasoline, paint, or flammable
liquids are used or stored.
Heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when
moving this heater.
DO NOT operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or
damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical
adjustment, or repair.
To disconnect heater, turn controls to off, wait for fans to stop, then remove plug from outlet.
Connect to properly grounded outlets only.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electrical shock, or injury to persons.
Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire.
This heater is for use on 120 volts. The adapter should not be used if a three-slot grounded receptacle is
available.
Heater must not be located immediately below a socket-outlet.
DO NOT use this heater in or around a bath, a shower, or a swimming pool.
SAVE THESE INSTRUCTIONS
USE RESTRICTIONS
