6
6
Pure Water Pack
™
INSTALLATION
L
OCATION
1.
The
Pure Water Pack
™
is designed for “under the sink” installation. The system should be mounted vertically,
to a secure wall or cabinet wall, which provides enough room to perform routine maintenance. This includes a
minimum of 14-15/16 inches from the chamber end, to allow for removal of the lamp and/or quartz sleeve, a
minimum of 6-inches on the backside of the water purifier, and a minimum of 2-inches free space under the filter
housings, to allow for housing removal, when changing filter cartridges.
Figure 1 -
Bio-Logic
®
Pure Water Pack
™
Installation
2.
The water purifier is intended for indoor use only. The water purifier should be protected from the elements and
from temperatures below freezing. The ambient temperature, in the area surrounding the water purifier, should be
between 33
F and 100
F.
3.
The water purifier must be connected to the cold water line only.
4.
The system should be located as close to the faucet as possible.
5.
CAUTION:
As with any water handling device, the water purifier should be located in an area where any
possible condensation or leakage from the water purifier, any purifier accessory and/or plumbing will not result in
damage to the area surrounding the water purifier. For added protection, it is recommended that a suitable drain
pan be installed under the purifier. The drain pan must be plumbed to an adequate, free flowing, drain to prevent
water damage in the event of a leak. There are numerous leak detection/flood stop devices, available on the market
today, designed to stop the flow of water, reducing the chance of water damage due to leakage. For more details
regarding leak prevention and/or limiting damages due to leaks, please contact the factory.
6.
The system should be located within 5-feet of an electrical receptacle. The receptacle must be a properly installed,
grounding type, receptacle that has Ground Fault Circuit Interrupter (GFCI) protection.
