04
6 - IDENTIFICATION OF THE PRESSURE LAMINATOR
7 - INSTALLATION
127v
220v
Product
label
Packaging
label
7.1
- Carefully unpack the laminator and check that it has not suffered any damage during transport.
7.2
- The laminator must be installed in a ventilated place, free from humidity, excessive heat and
supported on a flat and level rigid surface. Do not embed and do not place any material between the
support base and the bottom of the machine, so that this area is free, allowing air circulation. Leave at
least 20cm free between the entire perimeter of the laminator and another object, for its correct
operation when its moving parts are extended/open.
7.3
- Check the voltage of the local network before connecting the laminator to the outlet, remember that
this machine does not have dual voltage, so check the supply voltage (127V or 220V) before turning it
on. Variations in supply voltage of up to ± 10% of the rated voltage are allowed.
7.4
- Connect the power cable (19) to the input connector (18) located on the back of the equipment.
Connect the laminator power cable (19) to the electrical outlet with a properly installed grounding
system.
7.5
- Connect the compressed air network, with a pressure between 3 and 8 bar (43.5 to 116 psi), to the
quick coupling (17) of the air hose extender (16) of the laminator. Do not let the compressed air hose
bend and form creases. This will interrupt or decrease the airflow, impairing its operation. The
compressed air network must have a pressure regulator with an oil filter in order to avoid damage to the
laminator.
Attention:
The equipment must never be used without the hose extender (16).