Kapitel 5 Assembly of elmeg hybird 300
5.1 Installation process
This section describes the installation sequences.
Achtung
In operation, the elmeg hybird 300 must be mounted on a wall in the specified direction (top, see
image below).
(1)
Select an installation site no further than 1.5 metres from a 230V~ mains outlet and the NTBA (ISDN connecti-
on), as well as the network operator's DSL connection.
(2)
To prevent devices from interfering with each other, do not install the system close to electronics such as Hi-Fi
systems, office equipment or microwave ovens.
Do not install near heat sources, e.g. heating elements, or in damp rooms. Ambient temperature must remain
between 5°C and 40°C.
(3)
Borehole spacing guidelines for wall mounting are indicated at the back of the system (4). In selecting an instal-
lation site, a minimum distance of the system from other objects of about 100 mm must be observed.
(4)
System fixation points must rest firmly on the wall. Make sure that no supply lines, cables and the like are pre-
sent in marked borehole areas.
(5)
Drill the two upper fixation holes (1) and (2) at marked points. If mounting with 6 mm dowels, use a 6 mm ma-
sonry bit.
(6)
Insert the screws into both up per dowels in the wall so as to maintain a spacing of ca. 5 mm between screw
head and wall.
(7)
elmeg hybird 300 open:
bintec elmeg GmbH
5 Assembly of elmeg hybird 300
elmeg hybird 300 / 600
11
