• The module M 4 FXO has four connectors for use on analogue exchanges (HKZ / POTS).
• The IWV / MFV dialling method can be switched via the configuration.
• The transmission of CLIP information can be configured for each connector.
The signalling of a call on an analogue terminal shall only happen if all CLIP information has been fully transmitted
to the terminal.
• A central switch allows the detection of tariff information at either 16 kHz or 12 kHz.
The sending of tariff information (charge pulse) to analogue terminals is done in line with the configuration, tariff in-
formation is transmitted to S
0
terminals in the currency amount.
• The dial-end monitoring can be configured.
The time for monitoring the dial-end switches the voice channel to the extension only after the set time has elap-
sed.
• Dial tone detection
The tones and frequencies are country-specific.
• Keypad functions
When there is a connection via the module M 4 FXO connectors, the internal keypad dial is converted externally by a
MFC dial. If the connector is set to IWV then this function is not possible.
Hinweis
The settings are adjusted optimally ex works. They should only be amended if the various network pro-
vider provisions make it necessary to do so.
• GSM gateways can be switched on.
• Fixed network SMS messages are possible via the module.
8.9.1 Interface assignment FXO
A connection terminal plug and a RJ45 socket are both available as outputs. Both outputs are connected in parallel.
RJ45 Socket 1
RJ45 Socket 2
Connecting terminal 1
Connecting terminal 2
RJ45 Socket 1
RJ45 Socket 2
Connecting terminal 1
Connecting terminal 2
Number.
Name
Number.
Name
Number.
Name
Number.
Name
8
A1
8
A3
1
A1
1
A3
7
B1
7
B3
1
A1
1
A3
8 Mounting modules
bintec elmeg GmbH
40
elmeg hybird 300 / 600