GWR-2000 Four-wire 4-20 mA/HART
925-0335 Rev B
6 Set up with the display and adjustment module
38
Menu item
Default value
Modified value
Device memory - Measured value memory -
Stop with measured value
Not active
Device memory - Measured value memory -
Stop recording when memory is full
Not active
Additional adjustments
Menu item
Default value
Modified value
PIN
0000
Date
Actual date
Time
Actual time
Time - Format
24 hours
Probe type
Device-specific
The instrument settings are copied with this function. The following functions are available:
●
Read from sensor: Read data from sensor and save in the display and adjustment module
●
Write to sensor: Save data from the display and adjustment module back into the sensor
The following data or settings for adjustment of the display and adjustment module are saved:
●
All data of the menu "
Setup
" and "
Display
"
●
In the menu "
Additional adjustments
" the items "
Reset, Date/Time
"
●
Special parameters
The copied data are permanently saved in an EEPROM memory in the display and adjustment
module and remain there even in case of power failure. From there, they can be written into one
or more sensors or kept as backup for a possible electronics exchange.
Note:
Before the data are stored in the sensor, a check is carried out to determine if the data fit the
sensor. If the data do not fit, a fault signal is triggered or the function is blocked. When data are
being written into the sensor, the display shows which instrument type the data originate from
and which TAG-no. this sensor had.
Since scaling is very extensive, scaling of the level value was divided into two menu items.
In the "
Level 1
" menu item you define the scaling variable and the scaling unit for the level value
on the display, e.g. volume in l.
