Binatone TP-4055, Instruction Manual

Page: 7 / 36

7
ENGLISH
INSTRUCTIONS FOR USE
1. Place the appliance on a dry horizontal sur-
face.
2. Open the lid (3) by pulling the lid locking valve
(4) upward.
3. Fill the thermopot with water.
4. Make sure that the water level is not above a
mark «Full» on the water level scale (2). Do
not turn on the thermopot when empty. Minimum required
amount of water should not be lower than the lowest mark on
the water level scale.
Note: If the water level is lower than minimum amount, the
protection system preventing waterless operation
activates and the appliance is switched off.
5. Push the lid (3) to close it.
6. Connect the detachable power cable (15) and insert the plug
into a socket with a power supply with voltage that should
comply with the data indicated on the appliance.
7. When first connecting to a power supply, the indicator «Boil»
will light up and the thermopot will immediately start boiling.
Attention: Before the first use of the appliance, boil and
pour out water.
8. Immediately after boiling the thermopot will enter the water tem-
perature maintenance mode. Indicator «Keep warm» will light up.
9. To pour water out of the thermopot, press the button «Unlock»
and release the locking mode (presetting). The symbol «Un-lock»
will show that the locking mode is released. Place a cup under
the water supply port
(10) and press the button «Dispense».
Release the button when the cup is full. Ten seconds later the
water dispense mode will be set and the indicator «Unlock» will
go out.
10. Water can also be dispensed by using the manual pump (6).
Unlock the pump (6) by moving the manual pump lock lever
(7) to «Open». Place a cup under the water supply port (10)
and push the pump button. Release the button when the cup
is filled up. Move the manual pump lock lever
(7) to «Lock».
11.To supply water, the «Cup switch» (9) can be used. Press the
valve with a cup and move the cup away when the required
amount of water is dispensed.
12. For water dechlorination, press the button «Boil» for re-boil-
ing. In this case boiling time will be longer.
Before re-using the appliance, empty the water out — as wa-
ter can change its color and odor, and yellow spots could appear
on the heating element.
Attention:
To fully pour water out from the bulb, take off
the lid from the appliance and pour out water directly
from the internal bulb.