Installation and set-up
8
Charge the batteries for 15 hours
The battery charge level symbol should
increase by one bar every half hour when
you’re charging an empty battery. If you
think that the symbol isn’t showing the
correct battery charge level, remove and
refit the batteries.
Keeping the batteries charged
n
n
When you don’t need to use the
handset (for example, overnight or
when you go out), replace it on the
base unit or charger pod, to keep the
batteries charged.
Whenever the battery charge level
symbol shows ‘nearly empty’(
),
place the handset on the base unit or
charger pod to charge the batteries.
Before you use the handset for the first time,
it’s important to charge the batteries fully.
The handset ‘beeps’ when it’s correctly in
position on the charging cradle.
Leave the handset on the charging cradle
for 15 hours.
Make sure mains power is
switched on at the socket if you
want to use the phone — it will
not work without electrical power
Connect the base unit to the telephone line
Switch off power at the mains socket
Insert the telephone line plug into the
socket as shown
Switch mains power back on
9
Use the plug
to raise the
shutter before
pushing it
into the
socket
NOTE: the charger pod does not have
a connection to the telephone line.
Battery charge
level symbol
The Charge
light comes on.
http://www.binatoneonline.com/
6
CID