“My call was cut
off when I went
out of range.
Now I can’t use
my handset.”
Move the handset
closer
to the base unit before you try
again to make a call.
“There is inter-
ference and
noise on the
line.”
Move the handset
closer
to the base unit, or to a
different position.
Try moving the base unit so that it’s
not near other
electrical equipment
, such as a television or a
computer.
You’ll get the best results if you site the base unit
as
high as possible
. For example, in a two-storey house,
the first-floor landing is an ideal place for the base unit.
“I hear ‘beeps’
from my
handset while
I’m on a call.”
You may be going
out of range
of the base unit. Move
closer, or your call may be cut off.
Check the
Battery Level
symbol on the display. If it’s
low, recharge the batteries.
“The handset’s
display shows
”
Check that the base unit’s
mains power
adapter is
plugged in and power is switched on.
Move the handset
closer
to the base unit.
If you have a new handset, not supplied as part of your
original Symphony 2600 system, you need to register it
to the base unit (see page 28).
If the batteries have become completely run down (or if
the handset is switched off) and you place the handset
in the charging cradle, it may take about 5 minutes to
link with the base station. Wait and try again.
Troubleshooting
Searching
Binatone Help Line:
0845 345 9677
(Local Call rate)
47