BIMG METVISA AMG.130, Instruction Manual

Page: 14 / 28

14
ATTENTION!
Change the pressure regulator every 5 years or when it is defective.
Do not attempt to change the pressure regulator. Changing the pressure regulator
compromises safety in the use of the equipment, which may cause accidents.
Always use the gas cylinder in an upright position. Never overturn, pour or tilt the cylinder, as
the gas may flow into the liquid phase, canceling the pressure regulator function, which can
cause serious accidents.
Install the gas cylinder within the maximum distance allowed by the length of the hose
(approx. 80 cm). Never install the cylinder close to heated surfaces, and keep the gas
conductive hose protected from heat so it does not melt, causing fire or other accidents.
ATTENTION!
This equipment operates with LOW PRESSURE GAS. If your supply network has high
pressure, have the low-pressure outlet valve checked by a technician.
If the equipment is switched on at high pressure, the components will be damaged, in addition
to creating risks for the operator.
After installation and for your safety, check for gas leaks using soap suds only. If there is a
leak, inform the technician to repeat the installation.
If the leak persists, take the cylinder to a well-ventilated place and notify the company that
sells or distributes the cylinder.
IMPORTANT
The manufacturer is not responsible for possible direct or indirect damage caused by non-
compliance with the rules and instructions presented in this manual.
3.4 Safety Procedures and User Instruction
The professional who sells the equipment must instruct the user on the correct functioning of
the equipment and must hand over this instruction manual.
The user must be informed of the necessary safety measures and must respect them, as
well as all measures described in this manual.
Your equipment has mechanical protections (see item 1.2 Mechanical Safety). Removing or
tampering with these safety components can cause serious risks to the operator's upper limbs