13
A kit for installing low pressure gas is included with the equipment. The kit has a pressure
regulator (Cylinder 0.7/7.0 kgf/cm² - Regulator 5 kPa
– Flow 2 kg/h), a hose with connection for a gas
valve that must be fixed to a P13 gas cylinder.
The kit must be installed with the following recommendations:
•
Gas cylinder
– for this equipment, 01 cylinder with a minimum mass of 13 kg (code P13) of LPG
(liquefied petroleum gas) will be required. The cylinder must comply with the ABNT 8460 standard for
Brazil or according to the regulatory standard in force in your country. Check the product warranty
seal. If you have violated, do not install.
ATTENTION!
For gas installation code P45, contact the gas installation companies in your city.
•
Hose
– Screw the end that does not have the gas valve into the gas inlet valve, located behind the
lower right side of the rotisserie. The hose must not cross or be embedded in walls, and must not
make any type of splice (welding or gluing). Fix the ends only with appropriate clamps. Never use
wires or ribbons.
•
Pressure Regulator and Gas Register
– In the kit there is a pressure regulator and a gas register.
When installing the register on the cylinder, turn the butterfly nipple to the right, until it is firm. Never
use tools to perform this operation. The damper must remain closed whenever gas is not being used.
IMPORTANT
In addition to the instructions given in this manual, it is also recommended to follow the
cylinder manufacturer's instructions, as this item is not included with the equipment.
Summary of Contents for METVISA AMG.130
Page 1: ...1 ...
Page 24: ...24 Exploded View Drawing ...
