The Power Pack can run/charge 12VDC auto, RV,
marine, or other portable appliances that draw 10
amps or less.
The lower the amount of watts the appliance draws,
the longer the Power Pack can power it before needing
to be recharged.
Calculate the total wattage needed to run the
appliance before operation. You do not need to
calculate startup or surge wattages.
To calculate the size of the load you plan to use with
the Power Pack, use the following formula:
Amps x Volts = Watts
For example, if an appliance whose running amps total
7 amps, you will need 84 watts of power (7 amps x
12V = 84 Watts) to run the items. This figure is within
the capacity of the unit (10 amps x 12V = 120 Watts).
Note: Use this chart as a guideline only.
The actual power usage may vary based on the model
or brand of the appliance. Check the actual wattage of
your appliances and calculate the amount of power
needed to run/charge them.
DC APPLIANCE COMPATIBILITY
OPERATION
Jump Starting a Vehicle
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the “Charging the
Power Pack” section
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Power Switch on the Power Pack to
their OFF position. You may leave the Work Light
on if needed.
4. Connect the red Positive Battery Cable to
vehicle’s positive battery terminal. Connect the
black Negative Battery Cable to a non-moving
metal part of the vehicle.
5. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
6. WAIT FIVE MINUTES, then start the vehicle. If the
vehicle does not start, wait an additional 3 minutes
before trying again.
7.
After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove the
black Negative Battery Cable first, and then the
red Positive Battery Cable.
WARNING!
THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
Using the Work Light
1. To turn the Work Light on, press the Work Light
button.
2. To turn flashing lights on, press the Work Light
button again.
3. To turn the Work Light off, press the Work Light
button again.
Using the Air compressor
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the
“Charging the
Power Pack”
section on page 6.
2. Open the Air Hose Compartment on the back of
the unit and pull out the air hose.
3. Check the proper inflation level for the object that
is being inflated.
Tire Inflation
1. Position the Tire Inflator over the valve stem and
push down firmly, making sure it is fully seated.
2. Press the lever down.
3. Press the Air Compressor Switch on.
3
