7
8
9
10
11
12
With the Plain Gable (
PG
) held at the rear of the Floor (
FSS
) place a Window Panel (
WP
)
adjacent to it and fix them together with 50mm screws (
S50
). Screw the panels
together through the framing on the inside of the panels.
Tip: Pre-drill all holes before fixing.
WP
S50
S50
S50
FLOOR
PLAIN GABLE
WINDOW P
ANEL
S50
S50
S50
S50
S50
On the ground fix the three rear Plain Panels (
PP
) together with 50mm screws (
S50
).
Please note that the centre Plain Panel (
PP
) is narrower than the outer two panels.
Tip: Pre-drill all holes before fixing.
PP
PP
PP
S50
S50
S50
WP
On the ground fix the front Plain Gable Apex to the two front
Window Panels (
WP
) with 50mm screws (
S50
). Please note that the lower
corners of the Gable Apex reach out passed the Window Panels (
WP
). The boards of the
Gable Apex (
GA
) must be in-line with the boards of the Window Panels (
WP
) below.
Tip: Pre-drill all holes before fixing.
S50
S50
S50
WP
WP
PG
S50
S50
PGL
PGR
Fix the rear Plain Gable Apex (made from
PGL
and
PGR
) sections together with
50mm screws (
S50
).
Repeat this process for the front Plain Gable Apex (
PG
).
Tip: Pre-drill all holes before fixing.
PGL
PGL
PG
PGR
PGR
S50
S50
S50
PP
On the ground fix the rear Gable Apex (
PGL & PGR
) to the Plain Panel (
PP
) assembly with
50mm screws (
S50
). Please note that the lower corners of the Gable Apex reach out passed
the Plain Panels (
PP
).The boards of the Plain Gable Apex must be in-line with the boards of
the Plain Panels (
PP
) below.
Tip: Pre-drill all holes before fixing.
PP
PGR
FSS
FSS
Front
Rear
The floor panels (
FSS
) are made up of 4 Floor Joists (
FJ
) and 1 solid sheet board each.
4 Floor Joists (
FJ
) are evenly spaced out underneath the boards and fixed in place with
30mm nails (
N30
) at intervals of approximately 300mm. Place the floors side by side.
Tip: Use one of the joists to draw a line along the board to help locate where the joist will be when fixing them
in place. NOTE: The Floors (FSS) may come fully assembled.
IMPORTANT NOTE: To be erected correctly this building should be constructed and placed on a flat, level base.
Please refer to the Base Building guide for information on building a level base.
FJ
300mm
N30
N30
300mm
300mm
300mm
300mm
For Queries and Help please access our Support Centre: www.gardenbuildingsdirect.co.uk/help
