16
36
INSTALLATION
STEP 5: SADDLE INSTALLATION
Remove the saddle clamp bolts, barrel nuts, and upper and lower
saddle clamps with a T25 Torx wrench (4 mm Allen key on older
models).
To install the saddle, replace the two
saddle clamp bolts, barrel nuts, upper
and lower saddle clamps in the order
they were removed. Ensure that the
rails of your saddle rest in the channel
provided by the upper and lower
saddle clamps before tightening.
Adjust the saddle angle by tightening the two saddle clamp
bolts. Tighten both bolts evenly and alternately to the
maximum torque specified on the seatpost. Ensure that
the shaft or thread of the bolts does not contact the post
and cause the bolts to bend.
DIVINE saddle clamp works with standard rails, oval rails
and carbon rails.
CAUTION: GREASE SHOULD NOT BE USED ON THE THREADED
CONNECTIONS!
CAUTION:
With seatpost fully
dropped and rear suspension fully
compressed, make sure there
is sufficient clearence between
the saddle and the tire.
barrel nut
upper saddle
clamp
lower saddle
clamp
saddle clamp
bolts
Torx T25
Summary of Contents for DIVINE SL
Page 1: ...MANUAL DIVINE SL RASCAL ...